Re: [RFC 2/3] net: Provide switchdev driver for NXP's More Than IP L2 switch

[Andrew Lunn]

On Thu, Jun 24, 2021 at 04:35:42PM +0200, Lukasz Majewski wrote:
> Hi Andrew,
> 
> > > I'm not sure if the imx28 switch is similar to one from TI (cpsw-3g)
> > > - it looks to me that the bypass mode for both seems to be very
> > > different. For example, on NXP when switch is disabled we need to
> > > handle two DMA[01]. When it is enabled, only one is used. The
> > > approach with two DMAs is best handled with FEC driver
> > > instantiation.  
> > 
> > I don't know if it applies to the FEC, but switches often have
> > registers which control which egress port an ingress port can send
> > packets to. So by default, you allow CPU to port0, CPU to port1, but
> > block between port0 to port1. This would give you two independent
> > interface, the switch enabled, and using one DMA. When the bridge is
> > configured, you simply allow port0 and send/receive packets to/from
> > port1. No change to the DMA setup, etc.
> 
> Please correct me if I misunderstood this concept - but it seems like
> you refer to the use case where the switch is enabled, and by changing
> it's "allowed internal port's" mapping it decides if frames are passed
> between engress ports (port1 and port2).

Correct.


> 	----------
> DMA0 ->	|P0    P1| -> ENET-MAC (PHY control) -> eth0 (lan1)
> 	|L2 SW	 |
> 	|      P2| -> ENET-MAC (PHY control) -> eth1 (lan2)
> 	----------
> 
> DMA1 (not used)
> 
> We can use this approach when we keep always enabled L2 switch.
> 
> However now in FEC we use the "bypass" mode, where:
> DMA0 -> ENET-MAC (FEC instance driver 1) -> eth0
> DMA1 -> ENET-MAC (FEC instance driver 2) -> eth1
> 
> And the "bypass" mode is the default one.

Which is not a problem, when you refactor the FEC into a library and a
driver, plus add a new switch driver. When the FEC loads, it uses
bypass mode, the switch disabled. When the new switch driver loads, it
always enables the switch, but disables communication between the two
ports until they both join the same bridge.

But i doubt we are actually getting anywhere. You say you don't have
time to write a new driver. I'm not convinced you can hack the FEC
like you are suggesting and not end up in the mess the cpsw had,
before they wrote a new driver.

       Andrew