Re: [PATCH v3 1/9] ASoC: dt-bindings: qcom,qaif-cpu: Add binding

[Krzysztof Kozlowski]

On 01/09/2026 16:46, Harendra Gautam wrote:
>>>> The DT binding filename and compatible string do not match (qcom,qaif-cpu.yaml vs qcom,shikra-qaif-cpu).
>>>> Usually DT binding filenames are aligned with the compatible string for clarity.
>>>> Is there a reason for the naming mismatch?
>>> The filename reflects the controller; the compatible is
>>> variant-specific. This follows the same convention as
>>> qcom,lpass-cpu.yaml.
>>>>
>>
>> There is no compatible for controller and the only top-level compatible
>> listed there is "qcom,shikra-qaif-cpu", so that is your filename.
>>
>> And I already asked about this in v1. Why does this have to be repeated
>> at v3?
> The QAIF hardware IP is the same across platforms, only the board
> integration details differ. The binding is meant to describe the IP
> generically, with board-specific compatibles like qcom,shikra-qaif-cpu

The binding does not describe the IP generically, because bindings are
not generic.

> used to distinguish variants. I had qcom,qaif-cpu as the generic
> compatible in v2 but removed it in v3 as I was not clear about the
> guideline. Could you please suggest the right approach for the
> compatible and filename in this case?

Same comment, literally as v1.

Filename should match compatible, as in this case since it is single
compatible, filename should be equal to the compatible. So first you
determine what is your compatible and then you copy paste that string
into the filename and $id path.

Best regards,
Krzysztof