Re: [PATCH v2 2/2] usb: gadget: Add xilinx axi usb2 device support

[Felipe Balbi]

Hi,

On Wed, Apr 16, 2014 at 04:09:28PM +0530, sundeep subbaraya wrote:
> Hi Felipe,
> 
> On Thu, Apr 3, 2014 at 8:28 PM, Felipe Balbi <balbi@xxxxxx> wrote:
> 
> >> +static int start_dma(struct xusb_ep *ep, u32 src, u32 dst, u32 length)
> >
> > please prepend this with xudc_, it makes tracing a lot easier.
> >
> >> +{
> >> +     struct xusb_udc *udc;
> >> +     int rc = 0;
> >> +     unsigned long timeout;
> >> +
> >> +     udc = ep->udc;
> >> +     /*
> >> +      * Set the addresses in the DMA source and
> >> +      * destination registers and then set the length
> >> +      * into the DMA length register.
> >> +      */
> >> +     udc->write_fn(udc->base_address, XUSB_DMA_DSAR_ADDR_OFFSET, src);
> >> +     udc->write_fn(udc->base_address, XUSB_DMA_DDAR_ADDR_OFFSET, dst);
> >> +     udc->write_fn(udc->base_address, XUSB_DMA_LENGTH_OFFSET, length);
> >> +
> >> +     /*
> >> +      * Wait till DMA transaction is complete and
> >> +      * check whether the DMA transaction was
> >> +      * successful.
> >> +     */
> >> +     while ((udc->read_fn(ep->udc->base_address + XUSB_DMA_STATUS_OFFSET) &
> >> +                     XUSB_DMA_DMASR_BUSY) == XUSB_DMA_DMASR_BUSY) {
> >> +             timeout = jiffies + 10000;
> >> +
> >> +             if (time_after(jiffies, timeout)) {
> >> +                     rc = -ETIMEDOUT;
> >> +                     goto clean;
> >> +             }
> >> +     }
> >
> > don't you get an IRQ for DMA completion ? If you do, you could be using
> > wait_for_completion()
> 
> This function is called in interrupt context when buffer is ready or
> free. It initiates DMA to transfer data from IP buffer to memory.
> Hence it waits in busy loop till DMA completes

wait, so you start_dma() before your gadget driver asks you to ?

-- 
balbi

Attachment: signature.asc
Description: Digital signature