Re: [PATCH 1/2] arm64: dts: imx8mm-evk: add phy-reset-gpios for fec1

[Marco Felsch]

Hi,

On 20-02-14 16:27, Alifer Moraes wrote:
> imx8mm-evk has a GPIO connected to AR8031 Ethernet PHY's reset pin.
> 
> Describe it in the device tree, following phy's datasheet reset duration of 10ms.
> 
> Tested booting via NFS.
> 
> Signed-off-by: Alifer Moraes <alifer.wsdm@xxxxxxxxx>
> ---
> 
> Originally sent by Peng Fan <peng.fan@xxxxxxx>
> 
> Back then CONFIG_AT803X_PHY was set as "m" in defconfig so the boot process hung
> at nfs boot, now that CONFIG_AT803X_PHY is set as "y" by default, the patch works
> correctly.
> 
> Peng's original patch missed to pass the phy-reset-duration, according to the AR8031
> datasheet the reset GPIO needs to stay low for 10ms.
> 
> Original thread: https://lkml.org/lkml/2019/10/21/347
> 
>  arch/arm64/boot/dts/freescale/imx8mm-evk.dts | 2 ++
>  1 file changed, 2 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/freescale/imx8mm-evk.dts b/arch/arm64/boot/dts/freescale/imx8mm-evk.dts
> index 28ab17a277bb..11903ca86f0e 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mm-evk.dts
> +++ b/arch/arm64/boot/dts/freescale/imx8mm-evk.dts
> @@ -82,6 +82,8 @@
>  	pinctrl-0 = <&pinctrl_fec1>;
>  	phy-mode = "rgmii-id";
>  	phy-handle = <&ethphy0>;
> +	phy-reset-gpios = <&gpio4 22 GPIO_ACTIVE_LOW>;

Where is this gpio muxed?

Regards,
  Marco

> +	phy-reset-duration = <10>;
>  	fsl,magic-packet;
>  	status = "okay";
>  
> -- 
> 2.17.1
> 
> 
> 

-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |